5-55 Celsius operating temperature range.

0-2lpm recycling gas flow rate capacity.

RS232, RS485, Modbus, Profibus, and ProfiNet options.

Convenient and flexible configuration

Choose PED, TCD or FID detectors

2 sample inlet ports allow simultaneous analysis of two streams

Pre-configurable according to application requirements: ready-to-use device.

Stand-alone instrument for multiple trace impurity measurements.

Multiple detectors: PED, TCD and FID.

Explosion proof for use in Zone 1 and Zone 2

Integrate multiple instruments and sampling system all in one unit.

Easy to swap and access units inside the enclosure with its slide out design

Unique slide out design to offer easy access for maintenance without removing unit from gas sources.

Welded equipment and VCR fittings/valves/regulators to ensure proper installation for the semiconductor industry.

Installation of third party analyzers when required.

Detectors: PED, TCD, quartz crystal

Industrial communication protocols: (Modbus-Profibus with Ethernet/RS232/RS485).

Analog outputs: up to 10 x 4-20mA.

Maintenance interval/cost and lifetime of components

A choice across a multiple peak detection algorithms is automatically selected

Secure, administrator-controlled user access and permissions to ensure data integrity

Argon or helium carrier gas

Design ensure no dead-volume

All in one detector by replacing existing technologies commonly used

Ensures continuous supply of UHP helium carrier gas at 99.9999999 % purity.

Designed to complement LDetek GCs and accessories

Twin or single column options

Regulates supplies of specialty and UHP gases

High pressure compatible (up to 3500 psig/238 bar inlet, up to 145 psig/10 bar outlet)

Cv 0.06 flow capacity

Monitors the pressure of up to two gas sources simultaneously

High pressures capable: 0-3000 psig (0-350 bar)

Low pressure alarms

VCR type regulator

Designed for semiconductor applications

Internal surfaces b. A. Grade to e. P. 10 ra, 5 ra

316L Stainless Steel

Clean for UHP gas chromatography applications

No dead volume design

Compact design

2-step purification

Interchangeable getter

A compact design reduces project costs.

Leak proof, tested and certified

Air diffusion resistant

Automatic calculation of dilution concentrations

Automatic pressure controller

Broad range of dilution ratios (up to 1000 to 1)

High flows up to 20LPM to feed multiple analytical instruments

Two getters mounted in parallel with automatic switching via a network of pneumatic valves in case of purity level alarm to avoid flow interruption

Realtime gas quality monitoring with a mini-PED (plasma emission detector) integrated in the device to monitor trace N2 and H2O at the outlet of the purifier (Optional)

Electropolished Stainless Steel 316L gas lines

Quarter turn on/off diaphragm valves

Quick analysis time without drifting at low ppm/ppb